TurboChef Technologies 3240 User Manual

Page 10

INSTALLATION

NOTE:

When installing any gas pipes and/or making connections, observe all local

gas and building codes (refer to the regulations in force in the country in which the

appliance is being installed). Use the proper thread-sealing compound when installing

gas pipes.

DO NOT

use Tefl on

tape as thread sealant.

4.9

Remove the oven’s back panel and install the 8” (203.2 mm) gas pipe (refer to

page 2) between the two ovens.

NOTE:

Unless you are installing a triple-stacked oven, proceed to STEP 5, page 7.

4.10

If installing a triple-stacked oven, remove the gas pipe plug in the top of the

middle oven and repeat STEPS 1.1-2.6 (skip step 2.2), pages 3 and 4 for the top

oven.

4.11

Position the base ovens beneath the raised oven.

4.12

Lock the casters of the base oven.

4.13

Lower the raised oven onto the base ovens.

4.14

Remove the maneuvering casters from the back of the oven.

4.15

Immediately discard the maneuvering casters. These casters

are not designed to be used again.

4.16

Ensure that all the holes in the rear of the oven are plugged

with the provided bolts.

4.17

Install the stacking brackets to the middle and top ovens. Both stacking brackets

MUST be attached to the ovens.

WARNING: When installing any gas pipes and/or making connections, observe

all local gas and building codes (refer to the regulations in force in the country in

which the appliance is being installed). Use the proper thread-sealing compound when

installing gas pipes. DO NOT use Tefl on

tape as thread sealant.

4.18

Remove the burner compartment cover(s) and install the 8” (203.2 mm) gas pipe

(refer to page 2) between the middle and top ovens.

Step 4.9

Step 4.10

Step 4.17

Step 4.18

Step 4.14

Stacking Brackets