TOA Electronics C-DR161 CU Series - Manual (Page 79)

79
A U T O R E C S E T T I N G
S C H E D U L E
G R O U P – A
S E T T I N G
G R O U P – B S E T T I N G
G R O U P – C S E T T I N G
G R O U P – D S E T T I N G
G R O U P – E S E T T I N G
G R O U P – F S E T T I N G
S P E C I A L D A Y S E T T I N G
M O T I O N S E T T I N G
A U D I O O N
Item Selection Description
AUDIO ON / OFF ON: Audio is recorded simultaneously during auto recording.
OFF: No audio is recorded simultaneously during auto recording.
SCHEDULE For setting, refer to p. 79 ; Schedule.
GROUP A – F SETTING For setting, refer to p. 80 ; Setting of groups A – F .
SPECIAL DAY SETTING For setting, refer to p. 83 ; Special day setting.
MOTION SETTING For setting, refer to p. 84 ; Motion detection settings.
Note: Underlined settings represent factory-preset settings.
S C H E D U L E
D A Y S T A R T E N D O P E R A T I O N
1 E V E R Y 0 8 : 0 0 - 1 9 : 0 0 G R O U P – A
2 E V E R Y 1 9 : 0 0 - 0 8 : 0 0 G R O U P – B
3 S A T 0 8 : 0 0 - 1 3 : 0 0 G R O U P – C
4 S A T 1 3 : 0 0 - 2 3 : 5 9 G R O U P – C
5 S U N 1 3 : 0 0 - 0 8 : 0 0 G R O U P – D
6 S P E C I A L 0 8 : 0 0 - 1 3 : 0 0 G R O U P – F
7 S P E C I A L 1 3 : 0 0 - 0 8 : 0 0 G R O U P – A
8 - - - : - - - - - : - - - - - - -
9 - - - : - - - - - : - - - - - - -
1 0 - - - : - - - - - : - - - - - - -
1 1 - - - : - - - - - : - - - - - - -
1 2 - - - : - - - - - : - - - - - - -
E V E R Y
Item Selection Description
DAY Set the day of the week and special days for auto recording.
EVERY : Regularly performs recordings every day.
SUN - SAT : Performs recordings on the designated day of the week.
SPECIAL : Performs recordings on specified days.
Set the start time.
Set the end time.
Select groups. Groups can be set in the auto recording settings.
(Next page: setting of groups A - F)
START
END 00:00 - 23:59
GROUP A
- GROUP F OPERATION
00:00 - 23:59
EVERY / SUN /
MON / TUE / WED
/ THU / FRI / SAT/
SPECIAL
Note: Underlined settings represent factory-preset settings.
23.2. Auto-Recording Setting
Auto-Recording performs recording according to preset
schedules. Be sure to perform schedule or group settings when
making auto recording. (Refer to
p. 40 ; Auto recording.)
23.2.1. Schedule
To program schedules, set the day of the week, start and end
times, and service individually for each program. Up to 12
programs can be scheduled. Each schedule service is operated
according to group settings.
Notes
• When the same time is duplicated in the schedule settings,
the program setting of the largest number takes precedence.
• The auto recording function cannot be used if schedules are
not programmed.
• Setting the end time earlier than the start time will allow
recording to continue until the following day.