Trimble Outdoors R7 - Manual (Page 43)

Trimble R7/R8 GPS Receiver User Guide 3 1
Setting up the Receiver 3
Tr
imble R7 Operation
Internal Radio Setup
You can configure the Trimble R7 optional internal radio using any of
the following:
• the GPS Configurator software
• the WinFlash software
• the Trimble Survey Controller software
For more information, refer to the GPS Configurator Help, the
WinFlash Help, or the Trimble Survey Controller User Guide.
By default, the internal UHF radio has only a few frequencies
installed. Use WinFlash to configure additional frequencies. For more
information, see Adding frequencies for the 450 MHz internal radio,
page 74.
External Radio Setup
To use an external radio with the Trimble R7 receiver, you need an
external power source for the radio.
To set up a Trimble R7 using an external radio:
1. Connect one end of the yellow GPS antenna cable to the yellow
TNC port on the receiver.
2. Connect the other end of the GPS antenna cable to a Zephyr or
Zephyr Geodetic antenna.
3. Connect the external radio to Port 3 on the receiver.
4. Connect a radio antenna to the external radio.