Trimble Outdoors R7 - Manual (Page 101)

Trimble R7/R8 GPS Receiver User Guide 8 9
Default Settings 9
Tr
imble R7 Operation
94.3
Logging after power loss
If the Trimble R7 loses power unexpectedly, when power is restored
the receiver tries to return to the state it was in immediately before the
power loss. The receiver does not reset itself to defaults or apply any
Power Up settings. If the receiver was logging when power was lost
unexpectedly, it resumes logging when power is restored.
However, when you switch the receiver off using p, the receiver
behaves as if you pressed d to stop logging before you pressed p.
In this case, when power is restored normally, logging does not begin
until you start it manually.
94.4
Disabling logging
You can disable logging by setting the receiver’s data logging and
position logging rates to Off. However, if you press
d while logging
is disabled, the receiver will still log data, using the default logging
settings.
When the receiver is logging
data and then loses power … then when power
is restored, data
logging … and logging
settings are … and all other
settings are …
unexpectedly resumes
automatically the last settings
used the last settings
used
when you press p does not resume the factory
defaults the last settings
used
When you have disabled logging … then if you press d to start logging,
logging settings are …
using the Trimble Survey Controller or GPS
Configurator software the factory defaults
in the Power Up application file the factory defaults