beautypg.com

Programming the remote control, Chapter 1 introduction – Toshiba TP 50H60 User Manual

Page 15

background image

15

INTRODUCTION

1

2

3

4

5

6

7

8

9

ENT

100

0

CH

VOL

POWER

TIMER

RECALL

TV/VIDEO

MUTE

TV
CABLE

VCR

CH RTN

LIGHT

STOP SOURCE

ADV/

PIP CH

ADV/

PIP CH

FAV

FAV

PLAY PIP

REC

TV/VCR

REW

FF

STILL

LOCATE SWAP

STROBE

EXIT

FAVORITE

MENU/

PREVIEW

ENTER

To program the Remote Control

• This Remote Control is programmed to operate TOSHIBA VCRs.

• To operate VCRs (or Cable converters) other than TOSHIBA models,

perform the following procedures before operating.

Refer to the

“VCR code table” (or “Cable TV converter code table”)

on pages 16 and 17 to find the code number that corresponds to the
brand name of your VCR (or your converter).

If more than one number is listed, try each one separately until you
find the one that works.

Set the TV/CABLE/VCR switch to “VCR” (or “CABLE”).

While holding down RECALL, press the Number buttons to enter
the three digit code number for your brand of VCR (or converter).

Point the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
If the number is correct, the VCR should turn on.
If the VCR does not respond to the Remote Control, repeat steps

1 through 4 with another code number.

Reset the TV/CABLE/VCR switch to “TV” to control the TV.

Notes:
• Some newer VCRs are capable of working on either of two remote

codes. These VCRs have a switch labeled “VCR 1/VCR 2.”
If your VCR has this kind of switch, and does not respond to any of
the code numbers for your VCR brand name, set the switch to the
other position (“VCR 1” or “VCR 2”) and reprogram the Remote
Control.

• In some rare cases, you may not be able to operate your non-

TOSHIBA equipment with the supplied Remote Control. This is
because your equipment may use a code that is not provided with
this Remote Control. In this case, please use the equipment’s own
remote control.

CHAPTER 1

INTRODUCTION

Programming the Remote
Control

1

2

4

3

For future reference, write the code
number you set.
VCR CODE:

CABLE CODE:

Note:
You have to reprogram the Remote
Control when you change its batteries.

5