Toshiba TP 50H60 - Manual (Page 14)

14
INTRODUCTION
VCR and CABLE function buttons
• To control a TOSHIBA VCR, first set the TV/CABLE/VCR switch to “VCR.” The buttons shown below will then control
the VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program the Remote Control to control it. Details are on page 15.
• To control a cable TV converter, this Remote Control must be programmed to recognize the brand of your converter.
See page 15. The shaded buttons can be used to control the cable TV converter.
Set the TV/CABLE/VCR switch to “CABLE” whenever you want to control the cable TV converter.
Aim at the VCR or cable TV converter
CHAPTER 1 INTRODUCTION
Using the Remote with VCR
or Cable TV Converter
STOP
Press to stop the tape.
TV/CABLE/VCR switch
CABLE: To control a cable
TV converter
VCR: To control a VCR
Channel Number
Press the numbers to select
a channel.
REC
Press to start recording.
TV/VCR
Press to select the TV mode to
view one program while
recording another program.
POWER
Press to turn the VCR (or
cable TV converter) on.
Press again to turn off.
CHANNEL
Press to select the next
higher channel.
Press
to select the next
lower channel.
ENT
Some VCR’s and cable TV
converters require “ENT” to
change channel number.
PLAY
Press to begin tape playback.
FF
Press to rapidly advance a tape.
In playback mode, press to view
the picture moving rapidly
forward.
REW
Press to rewind a tape.
In playback mode, press to
view the picture moving
rapidly in reverse.
1 2 3
4 5 6
7 8 9
ENT 100 0
CH
VOL
POWER
TIMER
RECALL
TV/VIDEO MUTE
TV
CABLE
VCR
CH RTN
LIGHT
STOP SOURCE
ADV/
PIP CH
ADV/
PIP CH
FAV FAV
PLAY PIP
REC TV/VCR REW FF
STILL LOCATE SWAP
STROBE
EXIT
FAVORITE
MENU/
PREVIEW
ENTER