Thermador PC304 - Manual (Page 19)

Section 4: USING THE COOKTOP
17
Burner Placement in slots in back of grill
Using the Grill
Exploded Views and Side View of Grill
Follow the steps below to disassemble the
components in the grill box.
A. Remove the grill grate, stainless steel radiant
and burner from the grill box.
B. Remove the heat deflector from the slots on
the front panel of the grill box.
C. Remove the rectangular drip pan inside the grill
box as shown below.
Re-assembly
A. Replace the drip pan and heat deflector.
B. Insert the end of the burner into the slots at the
back of the grill box. Insert the tab on front of
the burner into slot in the heat deflector.
C. The stainless steel radiant lies on two (2) studs
on each end of the grill can.
D. Place the grill grate, with raised food contain-
ment rail oriented towards the grill box rear.
CAUTION:
• Use extreme care when placing the
grill components into the grill
compartment. Avoid contacting the
ceramic igniter which could break
preventing operation of the grill.
• The grill must be assembled as shown.
The drip tray heat shields must be in
place, and the burner must be properly
positioned relative to the gas supply.
Incorrect assembly of the grill may
result in unsafe or hazardous
conditions during operation.
• The grill radiant must be in place for
proper operation of the grill.
• Do not leave the grill unattended while
in use.
• Do not use charcoal briquettes or coals
of any kind.
Disassembly/Assembly of the Grill
Heat
Deflector
Grill Box
Drip Pan
U-shaped
burner
Grill
Grate
Stainless
Steel Radiant
Spark igniter