Teledyne C-2000 - Manual (Page 30)

®
21
(Rev. 8/04)
E1. Facsimile Calls Using a C-2000 Handset
Sending a Fax
1. Plug fax machine or PC into Handset.
2. If using a fax machine, insert document into the feeder.
3. Take handset off hook and verify dial tone.
NOTE: Some fax machines do not support a dialing capability.
In this case, the call must be dialed from the C-2000 handset.
In some instances, the airborne party may wish to dial a voice call to
the ground fax machine’s number prior to sending the fax. To switch
the voice mode call to fax mode, press “+” (Put Call on Hold) fol-
lowed by “3” (Fax) after the conversation is completed.
4. Establish a fax mode call by pressing “3” (Fax) on either the C-2000
handset, the PC, or the fax machine.
NOTE: It is not necessary to press “3” (Fax) if this C-2000 handset has been
configured as a Fax Station (See Section VI, B5). If the handset has been
configured as a PC station, the “3” (Fax) does not have to be entered
at the handset, but it must be entered from the PC or fax machine. The
C-2000 system uses the “3” (Fax) to distinguish a fax call from a data call.
5. On the fax machine or PC enter phone # and press “Start/Transmit.”
6. After the fax call is connected, the handset may be placed in its
holder.
7. At the completion of the call, press “End Call” to terminate the
connection.
NOTE 1: The airborne fax machine should be configured with its redial function off.
NOTE 2: As an alternative, the RJ-11 cord may be connected to a remote RJ-11
jack if one is provided for that handset.