Quatech WLNG-ET-DP500 Series - Manual (Page 15)

Quatech, Inc. Company Confidential
100-8081-100 Airborne CLI Reference Manual 15
5.0 Overview
The Airborne™ WLN Module includes a Command Line Interface (CLI) Server. The CLI
Server is the primary user interface for configuring, controlling, and monitoring Airborne™
WLN Modules. Users and OEM applications can establish CLI Sessions to the CLI
Server via the serial interface or a TCP connection on the wireless interface.
This document describes the CLI in full. Since different Airborne™ devices differ in
functionality, there may be differences in the use of the CLI for particular devices. These
differences are clearly identified as part of this document.
There are four primary module configurations supported by the Airborne Enterprise
Device Server family, these are UART, Serial, SPI and Ethernet. Each device types will
be described below. In some cases multiple interface option are available within a
specific configuration, the functionality of these interfaces does not vary between device
configurations unless specifically noted within the device description.
5.1 UART
The UART (Universal Asynchronous Receiver/Transmitter) interface is a digital
interface that supports full duplex transfer of data serially between the module
and a connected host. It supports the following settings:

BAUD: 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800, 38400,
57600, 115200, 230400, 460800, 921600

Flow Control: None, Hardware (CTS/RTS), Software (XON/XOFF)

Default settings: 9600, N, 8, 1, No Flow Control.
5.2 Serial
The Serial device includes both a UART interface control and I/O lines to
manage external logic for RS232/422/485 line drivers. It supports the following
settings:
 BAUD: 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800, 38400,
57600, 115200, 230400, 460800, 921600

Flow Control: None, Hardware (CTS/RTS), Software (XON/XOFF)

Mode (RS232/485), Tx Enable, Rx Enable.
Default settings: 9600, N, 8, 1, No Flow Control.
5.3 Ethernet
The Ethernet interface supports a fully compliant 10/100 Ethernet interface
capable of supporting all full and half-duplex rates. The rates are configurable
through the CLI interface.
The module includes a Broadcom BCM5241A Ethernet PHY, please refer to the
manufacturers datasheet for interface details and appropriate design guidelines.