Oki 4M - Manual (Page 55)

3 - 19
3.3.12 Separator Guide
(1) Dismount the upper cover assy. (See Section 3.3.4.)
(2) Dismount the high-voltage power supply board. (See Section 3.3.5.)
(3) Remove four screws 1 .
(4) Dismount inlet 2 from base frame 3 .
2 >
Insert a screwdriver into the hole on the side of base frame 3 , remove the inlet claw from
base frame 8 , and dismount inlet 2 .
(5) Disconnect three cables 4 and connector A and dismount base frame 3 . Then, remove
screw 0 and disconnect FG cable B .
A >
Dismount connector A by drawing it upward while pushing the clamp lever with a standard
screwdriver.
(6) Dismount the paper holder assy. (See Section 3.3.7.)
(7) Dismount two engagements and sheet guide 5 .
(8) Dismount friction pad 6 , compression spring S 7 , and separator guide 8 .
(9) Dismount paper sensor E 9 .