Onkyo AV Receiver TX-NR5010 - Manual (Page 96)

Controlling Other Components
En-96
Onkyo components that are connected via are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
Controlling Onkyo components without
If you want to control an Onkyo component by pointing the
remote controller directly at it, or you want to control an
Onkyo component that’s not connected via
, use the
following remote control codes:
` 30627:
Onkyo DVD player without
` 71817:
Onkyo CD player without
` 32900/33100/33500:
Onkyo Blu-ray Disc player
` 32901/33104/33504:
Onkyo HD DVD player
` 70868:
Onkyo MD recorder without
` 71323:
Onkyo CD recorder without
` 82990:
Onkyo Dock without
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
By pressing the REMOTE MODE button that’s been
programmed with the remote control code for your
component, you can control your component as described
below.
For details on entering a remote control code for other
components, see “Entering Remote Control Codes”
(
➔ page 95 ).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the
*1 (limited to
some models). The TV must be able to receive remote
control commands via
and be connected to the
AV receiver via HDMI. If controlling your TV via
doesn’t work very well, program your TV’s
remote control code into TV and use the TV remote mode
to control your TV.
Use the following remote control codes:
` 11807/13100/13500:
TV with
Controlling Apple TV
By programming the supplied remote controller with the
appropriate remote control code, you can use it to operate
your Apple TV.
Use the following remote control codes:
` 02615:
Apple TV
Remote Control Codes for Onkyo
Components Connected via RI
1 Make sure the Onkyo component is connected with
an cable and an analog audio cable (RCA).
See “Connecting Onkyo RI Components” for details
(
➔ page 25 ).
2 Enter the appropriate remote control code for a
REMOTE MODE button, by referring to the
previous section.
` 42157:
Onkyo cassette tape deck with
` 81993:
Onkyo Dock with
3 Press the REMOTE MODE button, point the
remote controller at the AV receiver, and operate
the component.
Resetting the REMOTE MODE Buttons
1 While holding down the REMOTE MODE button
that you want to reset, press and hold down HOME
until the REMOTE MODE button lights (about 3
seconds).
2 Within 30 seconds, press the REMOTE MODE
button again.
The REMOTE MODE button flashes twice,
indicating that the button has been reset.
Each REMOTE MODE button is preprogrammed
with a remote control code. When a button is reset, its
preprogrammed code is restored.
Note
• The learning command is also reset.
Resetting the Remote Controller
1 While holding down RECEIVER, press and hold
down HOME until RECEIVER lights (about 3
seconds).
2 Within 30 seconds, press RECEIVER again.
RECEIVER flashes twice, indicating that the remote
controller has been reset.
Controlling Other Components