beautypg.com

Controlling multi zone components, Cator, Adjusting the volume for zones – Onkyo AV Receiver TX-NR5010 User Manual

Page 89: Enabled, Abled

background image

Advanced Operations

En-89

Operating on the AV receiver

Tip

• The Whole House Mode function shares the input source of main

room with Multi Zone (

page 55

).

Operating on the remote controller

To control Zone 2/3, you must press ZONE on the remote
controller first.
ZONE turns red when Zone 2 is on, and green when
Zone 3 is on.

Adjusting the Volume for Zones

Operating on the remote controller

Operating on the AV receiver

If your Zone 2/3 speakers are connected to a receiver or
integrated amplifier in Zone 2/3, use its volume control to
adjust the volume.

Controlling Multi Zone Components

1

To turn on Zone 2/3 and select an input source,
press

ZONE 2 or ZONE 3 followed by an input

selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.

Tip

• The corresponding trigger output goes high (+12 V).

To select AM or FM, press ZONE 2 or ZONE 3 and
the TUNER input selector repeatedly.

To select the same source as the main room’s, press
ZONE 2 or ZONE 3 twice. “Zone 2 Selector:
Source
” or “Zone 3 Selector: Source” appears on the
AV receiver’s display.

ZONE 3

ZONE 2

OFF

MASTER VOLUME

Input selector buttons

2

To turn off Zone 2/3, press

ZONE 2 or ZONE 3.

The Z2/Z3 indicator on the AV receiver’s display
flashes. Press

OFF.

The zone is turned off.

Tip

• The corresponding trigger output goes low (0 volts).

1

Press

ZONE repeatedly, then point the remote

controller at the AV receiver and press

RECEIVER.

Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.

Tip

• The corresponding trigger output goes high (+12 V).

2

To select an input source for Zone 2/3, press

ZONE

repeatedly, followed by an

INPUT SELECTOR

button.
To select AM or FM, press ZONE and the TUNER
input selector repeatedly.

RECEIVER

MUTING

VOL /

ZONE

Input selector buttons

3

To turn off Zone 2/3, press

ZONE repeatedly,

followed by

RECEIVER.

The zone is turned off.

Tip

• The corresponding trigger output goes low (0 volts).

1

Press

ZONE repeatedly.

2

Use

VOL / .

1

Press

ZONE 2 or ZONE 3 (the Z2/Z3 indicator on

the AV receiver’s display flashes).

2

Use

MASTER VOLUME control within 8 seconds.