Onkyo AV Receiver TX-NR5010 - Manual (Page 61)

Advanced Operations
En-61
Note
• This procedure can also be performed on the AV receiver by
using SETUP, the cursor and enter (middle) buttons.
• During Audyssey MultEQ ® XT32 Room Correction and Speaker
Setup, messages, etc., that are displayed on the TV screen will
appear on the AV receiver’s display.
Explanatory Notes
Main Menu
Sub Menu
Setting target
Setting options (def ault setting underlined)
Using the Setup Menu (HOME)
1 Press RECEIVER followed by HOME.
2 Use / to select “Setup”, and then press ENTER.
3 Use / to select a main menu item, and then press
ENTER.
4 Use / to select a sub menu item, and then press
ENTER.
5 Use / to select a setting target, and use / to
change the setting.
Press HOME to close the menu.
Press RETURN to return to the previous menu.
RETURN
HOME
RECEIVER
ENTER
///
■ Screen Saver
If there is no video signal on the current input source and
no operation for a specific time (three minutes by
default), a screen saver automatically comes on.
Tip
• The time until the screen saver activates itself can be changed
in the “Screen Saver” setting ( ➔ page 83 ).
• The screen will return to its previous state if the AV receiver is
operated.
Main Menu Speaker Setup
Speaker Configuration
■ Subwoofer
` 1ch:
Audio signal is outputted from SW1 jack
only.
` 2ch:
Audio signal is outputted from SW1 and
SW2 jacks.
Main Menu
Sub Menu