One for All Kameleon URC-9964B00 - Manual (Page 39)

U
SER
’
S
G
UIDE
Using Channel Scan 39
USING CHANNEL SCAN
In the AUX, CBL/SAT, or TV mode, use the FAV key to start a 3-second scan of
all channels. If programmed, use the FAV key to scan only your favorite
channels to view a channel (see Programming Favorite Channel Scan below).
1. Press AUX, CBL/SAT, or TV once.The two bottom IR segments flash once.
2. Press FAV once.The IR segments display outgoing animation as each
channel is changed.
• If Favorite Channel Scan has been set up, scanning of favorite
channels starts and cycles through stored channels for 3 minutes
or until stopped by pressing any key.
• If Favorite Channel Scan has not been set up, scanning starts with
the current channel, then proceeds to the next channel up and
cycles through all channels for 3 minutes or until stopped by
pressing any key.
3. To stop scanning channels at any time, press any key once.
PROGRAMMING FAVORITE CHANNEL SCAN
In the AUX, CBL/SAT, or TV mode, you can store a list of up to 10 favorite
channels, in any order, that are immediately scanned when FAV is pressed
(see Using Channel Scan above).
NOTE: . Favorite channels can only be programmed for one mode. After
programming, if FAV is pressed while in another mode, the remote control starts
a normal channel scan instead (if applicable to the selected device).
2. Select a Favorite Channel Mode by pressing AUX, CBL/SAT, or TV
once.The two bottom IR segments flash once as the selected device key
animates.
1. Press and hold SETUP until the two bottom IR
segments flash twice. The Program Keys
appear as SETUP flashes repeatedly
OFA Kameleon wRF UG rev 3.fm Page 39 Monday, September 13, 2004 11:18 AM