Changing volume lock, Uide – One for All Kameleon URC-9964B00 User Manual
Page 27
U
SER
’
S
G
UIDE
Changing Volume Lock
27
O
PTIMIZING
IR/RF B
ASE
S
TATION
R
ECEPTION
Here are some adjustment tips for optimizing the operation of your IR/RF
Base Station:
•
Aim the OFA Kameleon 8-Device Remote with RF toward the room
where the IR/RF Base Station is located.
•
Do not position the IR/RF Base Station near metal objects, such as heat
ducts. Metal can absorb RF signals.
•
Make sure the batteries in the OFA Kameleon 8-Device Remote with RF
are fully charged. Try replacing them if you are not sure (see “Installing
Batteries” on page 4). Weak batteries will affect the signal range.
•
Make sure that the OFA Kameleon 8-Device Remote with RF is not being
affected by other RF transmissions (e.g., garage door openers, cordless
telephones, etc.).
NOTE: The tests for range limits of the OFA Kameleon 8-Device Remote with RF
and the IR/RF Base Station were conducted in open-air distance tests. Actual
signal distance will be based on the construction of the building the unit is
being used in, as well as other factors, such as outside interference.
CHANGING VOLUME LOCK
The OFA Kameleon 8-Device Remote with RF is set at the factory for
independent volume control of each selected device.
However, you may change the Volume Lock setting to Global Volume Lock
so that a device’s volume is locked to one mode (e.g., to control TV volume in
all other modes). After that you can perform Individual Volume Unlock on a
selected device to set its volume control for independent operation.
L
OCKING
V
OLUME
C
ONTROL
TO
O
NE
M
ODE
(G
LOBAL
V
OLUME
L
OCK
)
1.
Press and hold SETUP until the two bottom IR
segments flash twice. The Program Keys
appear as SETUP flashes repeatedly.
OFA Kameleon wRF UG rev 3.fm Page 27 Monday, September 13, 2004 11:18 AM