One for All Kameleon URC-9964B00 - Manual (Page 31)

U
SER
’
S
G
UIDE
Using Macros 31
5. To save the macro, press and hold SETUP until the two bottom IR
segments flash twice. The Program Keys appear again.
6. Exit programming by pressing HOME once. The display returns to the
last-selected device menu screen
.
7. Now, if you aim the remote control at the devices selected in step 4 and
press the programmed Macro Key once, the TV turns on and tunes to
channel 3. Then the Cable Box turns on and tunes to channel 071.
P ROGRAMMING A M ASTER P OWER M ACRO IN THE H OME T HEATER M ODE
A macro can be programmed onto the POWER key to turn on or off as many
as seven Home Theater devices.
NOTE: This following example assumes the Home Theater system contains a
Satellite Receiver, a DVD Player, an Audio Receiver, and a TV.
2. Press MACRO once.The Macro programming screen appears:
5. To save the power macro, press and hold SETUP until the two bottom IR
segments flash twice. The Program Keys appear again.
6. Exit programming by pressing HOME once. The display returns to the
last-selected device menu screen
.
7. To test the power macro, first make sure all home theater devices
selected in step 4 are turned on. Aim the remote control at the devices
1. Press and hold SETUP until the two bottom IR
segments flash twice. The Program Keys
appear as SETUP flashes repeatedly.
3. Press POWER once.The last-selected
device menu screen, including HOME,
appears.
4. Enter the macro sequence. For this
example, press CBL/SAT once, followed
by POWER once. Next, press DVD once,
followed by POWER once.Then press
AUDIO once, followed by POWER once.
Finally, press TV once, followed by
POWER once.
OFA Kameleon wRF UG rev 3.fm Page 31 Monday, September 13, 2004 11:18 AM