Omron Programmable Terminals NT631C - Manual (Page 108)

91
Connecting to the Host’s RS-232C Port Section 5-1
Cables with Connectors Made by OMRON
When connecting an NT-AL001 and a PLC, use the OMRON cables with con-
nectors indicated in the table below.
Note 1. The maximum tensile load of the recommended cable is 30 N. Do not ex-
ceed this load.
2. After connecting a connecting cable, always tighten the connector screws.
Recommended Connectors, Cables and Crimp Terminals for RS-422A/
485
When making an RS-422A/485 connecting cable, as far as possible use the
recommended parts indicated in the table below. Some Units come supplied
with one connector and connector hood.
Check the required parts and prepare them in advance.
Connector
hood XM2S-0911 9-pin type
Made by OMRON
C-series CQM1, C200HS,
C200HX/HG/HE(-Z)E
CVM1/CV-series CPU Units
CV500-LK201
XM2S-0913 Made by OMRON 9-pin
XM2S-0911-E Made by OMRON 9-pin CS/CJ-series CPU Units
XM2S-2511 25-pin type
Made by OMRON
C500-LK203
3G2A5-LK201-EV1
C200H-LK201-V1
DB-C2-J9 25-pin type
Made by JAE
3G2A5-LK201-EV1
3G2A6-LK201-EV1
Cable AWG28 ×5P
IFVV-SB
Multi-core shielded
cable
Made by Fujikura, Ltd.
CO-MA-VV-SB
5P
×28AWG
Multi-core shielded
cable
Made by Hitachi, Ltd.
Model Cable Length Connector Specification
XW2Z-070T-1 0.7 m 9-pin ⇔ 9-pin
Host link, NT Link (1:1), NT Link (1:N)
+5 V power supplied from PLC
(Use when the PLC has a +5 V output.)
XW2Z-200T-1 2 m
Name Model Remarks Delivered with
Name Model Maker Remarks
Connector XM2A-2501 25-pin type
Made by OMRON
Delivered with the following
Units:
C500-LK203
DB-25P F-N 25-pin type
Made by JAE
Delivered with the following
Units:
3G2A6-LK201-EV1
3G2A5-LK201-EV1
Connector
hood XM2S-2511 25-pin type
Made by OMRON
Delivered with the following
Units:
C500-LK203
DB-C2-J9 25-pin type
Made by JAE
Delivered with the following
Units:
3G2A6-LK201-EV1
3G2A5-LK201-EV1