Olympus LS-100 - Manual (Page 51)

1
EN
3
Era
sin
g
Partially erasing a file
You can erase an unwanted part of a PCM
format file recorded with this recorder.
1
Play the file you wish to partially
erase.
• Locate the beginning of the part you
wish to erase. If the file is long, you
can use the 9 button to locate the
beginning of the part to erase.
2
At the beginning of the part to
erase, press the ERASE button.
• [Erase started] will flash on the
display.
• Playback continues while [Erase
started] is flashing, and you can
still fast-forward or rewind just as in
normal playback, allowing you to
quickly locate the end position. If the
file reaches the end while the message
is flashing, the file's end becomes the
end position of the partial erase.
Erasing
3
Press the ERASE button again at
the position where you wish to
end the partial erase.
• [Start point] and [End point] will
flash alternately on the display.
4
Press the ERASE button.
• The display switches to [Partial
erasing!], and partial erasing starts.
[Partial erase completed] appears
when the file is partially erased.
• If you do not press the ERASE button
within 8 seconds, partial erase will be
canceled, and the recorder will return
to the playback mode.