Olympus LS-100 - Manual (Page 125)

1
EN
8
Tro
ub
le
sh
oo
tin
g
Troubleshooting
Symptom Probable cause Action
Nothing appears on
the display
The battery is not loaded properly
Verify that the battery's polarities + and - are correct (☞
page 22).
Battery power is getting low.
Charge the battery or replace with a new battery
(☞ page 22).
The power is off. Turn the power on (☞ page 25).
Won't start
Battery power is getting low.
Charge the battery or replace with a new battery
(☞ page 22).
The power is off. Turn the power on (☞ page 25).
The recorder is in HOLD mode. Release the recorder from HOLD (☞ page 26).
Unable to record
No remaining memory. Erase unnecessary files (☞ page 50).
The maximum number of files
has been reached.
Change to any other folder (☞ page 37).
No playback sound
heard
The headphone is connected. Unplug the headphone to use the internal speaker.
The volume level is set to [ 0]. Adjust the volume level (☞ page 46).
Recording level too
low
The recording level has not
been adjusted. Adjust the recording level and then try recording once
more (☞ page 70).
The microphone sensitivity is too
low. Set [Mic Sense] to [HI] or [MID] and then try recording
once more (☞ page 80).
This could potentially be because
the output level for the connected
external devices is too low. If adjusting the recording level does not help you
get a clear recording, adjust the output level for the
connected devices.
Files are not recorded
in stereo The connected external
microphone is monaural.
When recording while an external monaural
microphone is connected, the sound will only be
recorded by the L-channel.
Noise is audible
through the
recording monitor
Acoustic feedback is occurring.
When the built-in speaker amps and the like are
connected there is a risk that audio feedback will occur
while recording.It is recommended that you use a
headphone for the recording monitor.
Perform adjustments, such as further distancing the
headphone from the microphone, and not pointing
the headphone at the microphone.
Unable to set index
marks
The maximum number of marks
(99) has been reached.
Erase unnecessary marks (☞ page 45).
The file is locked. Unlock the file (☞ page 90).
The file is read-only.
Unlock the file or cancel the read-only setting of the file
on the PC.