Olympus C-2040ZOOM - Manual (Page 108)

108
4
Custom Photography
Setting the color tone (Quick Reference White Balance)
Place a sheet of white paper
under the light source so
that the light strikes the
paper (or get someone to
hold the paper). Then frame
the shot so that the illumi-
nated paper fills the screen
and press the [OK] button.
● The white balance is registered
and you can use the monitor to
check whether the new setting
is effective.
Press the [OK] button
repeatedly until the correct
setting is achieved.
Press the (Menu) button to
exit the quick reference white
balance registration screen.
● To reset the white balance again,
repeat the procedure from step 4.
● To cancel Quick Reference
white balance, select "AUTO"
and press the [OK] button.
● You can still take pictures at
this point.
Press the [OK] button.
Press the [OK] button
again to save the setting
and exit Menu mode.
● When Quick Reference White
Balance is set, " " is dis-
played on image information
screen in Playback mode.
(P.146)
8
7
6
5
•
If you cannot distinguish the adjustment, always view your shot on the mon-
itor to check the color tones.
•
Use the AUTO setting for normal shots.
•
Unless you select "OFF" in the "ALL RESET" setting (P.173), this setting will
be cancelled when you switch the camera off.
8 7 5 6
HQ
SIZE:1600 1200
F2.0 1/800 +2.0
ISO400
12.23.,00 21:56
FILE:123-3456
10
When still picture playback screen
is displayed. (INFO-ON)