Roland VGA-3 - Manual (Page 28)

28
Additional Data
Calling Up the Factory Tone Settings for Each Individual Bank
You can select any one of the Banks 0–3 listed on the Memory Sheet (p. 33) and call up that bank’s factory-loaded settings to
MEMORY buttons 1–10.
* Calling up these settings clears all of the Memories 1–10 previously stored in Bank 0.
1. While holding down the Memory button corresponding to the bank on the Memory Sheet that you want to call up, switch
ON the POWER switch.
To call up the Memory Sheet Bank 0 tone settings: [1/6]
To call up the Memory Sheet Bank 1 tone settings: [2/7]
To call up the Memory Sheet Bank 2 tone settings: [3/8]
To call up the Memory Sheet Bank 3 tone settings: [4/9]
For example, if you want to call up the tone settings for Bank 2 on the Memory Sheet, hold down [3/8] and switch the power
on. The [3/8] indicator flashes.
* If you want to cancel the operation, turn the power off.
2. Press [WRITE] two times.
The [WRITE] indicator flashes; once the settings have been called up, the VGA-3 returns to memory Number 1.