Roland VGA-3 - Manual (Page 22)

22
Using the GFC-50 to Operate the VGA-3
By connecting a GFC-50 foot controller (optional), you can use your foot to operate the VGA-3.
Use the VGA-3’s factory MIDI settings.
Connecting the VGA-3 and
the GFC-50
Connect the VGA-3 and the GFC-50 with a MIDI cable.
fig.0180
Switching Memories With
the GFC-50
The VGA-3's forty memories are divided up into Banks 0, 1,
2, and 3 as shown below.
You can use the GFC-50 to call up and store (write) settings
in all of the memories.
The forty memories can be accessed by specifying them in
terms of the GFC-50's banks (0–3) and numbers (1–10).
fig.0190
How to Call Up the VGA-3’s
Memories Using the GFC-50
fig.0200
1. Press the GFC-50’s Bank button (1) to select from Banks
0, 1, 2, or 3.
2. Select a memory Number 1–10 with the GFC-50’s pedal
(2).
Here, the memory number selected with the pedal is also
indicated by the VGA-3’s memory button indicator.
If Bank 1, 2, or 3 is specified with the foot controller, and
the power is turned off and then on again, the VGA-3’s
memory still returns to Bank 0.
GFC-50
MIDI OUT
MIDI IN
Bank 3
10 Bank 2
10 Bank 1
10
1 2 ...
Bank 0
9 10
GFC-50
(2)
(1)