Clean the air filter – Rimage Everest III User Manual
Page 33
Maintain the Everest printer
110875_A
27
Clean the air filter
1. Power off the printer.
2. Remove
the
air filter
.
a. At the rear of the Everest
printer, remove the two screws
holding the fan cover.
b. Remove
the
air filter
.
3. Clean
the
air filter
.
a. Use water to clean the air filter.
b. Allow
the
air filter
to dry.
Screws
Fan cover
4. Prepare
the
printer
for use.
a. When
the
air filter
is dry, place it inside the fan cover.
b. Use
the
two screws
to attach the fan cover.
5. Power on the printer. The printer is ready.
Clean the platen roller with the Everest cleaning kit
-
Important!
Clean the platen roller only if you notice a diminished print quality, such as white
specks on the printed disc.
Before you begin:
A. Ensure that the printer is powered off.
B. At the back of the printer, change the mode
switch
to position 3 (Diagnostic Mode).
C. Power on the printer.
Clean the platen roller:
1. Access
the
platen roller
.
a. Press
the
two side cover latches
to release the side cover.
b. Lower
the
side cover
.
c. Open
latches 1
, 2, and 3.
d. Remove
the
print ribbon carrier
. For specific instructions, see Changing the print
e. Pull out the retransfer ribbon carrier. For specific instructions, see Changing the
retransfer ribbon. Refer to page 23.
Note:
The retransfer ribbon carrier cannot be removed from the printer.
2. To access and select diagnostic 1, press and hold the operator button for 2 seconds. The
platen roller rotates and the front panel Active indicator light blinks.