Cleaning the everest printer, Clean the print head with the everest cleaning kit, N see – Rimage Everest III User Manual
Page 31: Cleaning the, Everest printer, Refer to
Maintain the Everest printer
110875_A
25
Cleaning the Everest printer
Clean the print head with the Everest cleaning kit
1. Power off the printer.
2. Access
the
print head
.
a. Press
the
two cover latches
to release the side cover.
b. Lower
the
side cover
.
c. Open
latch 1
.
d. Remove
the
print ribbon carrier
. For specific instructions, see Changing the print
3. Clean
the
print head.
p
Caution!
Wipe the print head from
one end to the other. Do not stop
wiping in the middle of the print
head.
p
Caution!
Do not scratch the print
head. The white area in the picture
shows the area to clean.
Print head
Latch 1
Wipe
direction
a. Apply
isopropyl alcohol
to the sponge swab.
b. Use
the
sponge swab
to wipe across the print head from one end to the other.
c. Repeat as needed until the print head is clean of dust and debris.
d. Use
the
sponge swab
to remove any waxy buildup from the roller below the print head.
4. Prepare
the
printer
for use.
a. Install
the
print ribbon carrier
.
b. Close
all
latches
.
c. Close
the
side cover
.
5. Power on the printer. The printer is ready.