5 rip, Overview, Configuration – RCA 605 User Manual
Page 138: Interfaces, Neighbours, Chapter 5
128
E-DOC-CTC-20051017-0151 v1.0
Chapter 5
Expert Configuration
5.3.5 RIP
Overview
The RIP web page contains three tabs:
Configuration
The Configuration section allows you to enable/disable the SpeedTouch™ RIP
functionality and configure the some basic RIP settings.
Interfaces
The RIP Interfaces table allows you to configure interface specific RIP settings such
as:
Override the master RIP status (enable/disable)
Override the master RIP version, separately for receiving and sending RIP
messages
Specify whether authorization is needed or not, and if so the required
authorization string
Specify whether routed must be included in RIP updates sent to a gateway
from which the updates were learned
Specify whether the interface should transmit RIP updates or not.
Neighbours
Optionally, the RIP Neighbours table allows you to define one or more RIP
neighbours. This may be necessary in cases where multicast messages can not be
sent or received among the network.