Radio Shack ET-1106 - Manual (Page 10)

10 Preparation
Cautions:
You must use a Class 2 power source that sup-
plies 9V DC and delivers at least 300mA. Its cen-
ter tip must be set to positive and its plug must fit
the phone's 9V DC jack. The supplied adapter meets these
specifications. Using an adapter that does not meet these
specifications could damage the phone or the adapter.
• Always connect the AC adapter to the phone before you
connect it to AC power. When you finish, disconnect the
adapter from AC power before you disconnect it from the
phone.
ˆ
Preparation
CONNECTING AND CHARGING THE
BATTERY PACK
Your phone comes with a rechargeable nickel-metal-hydride
battery pack. You must connect the battery pack and charge it
for at least 16 hours before you use the phone.
Important: You must install the battery pack inside the handset
before charging the phone and using it.
To connect the battery pack, slide the battery compartment cov-
er in the direction of the arrow to remove it. Install the recharge-
able battery pack in the compartment as indicated by the
polarity symbols (+ and –) marked inside. Then replace the cov-
er.
!
43-1106.fm Page 10 Wednesday, April 26, 2000 10:30 AM