Roberts Radio iStream - Manual (Page 87)

If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri) 86
Display and Audio .
Auxiliary input socket
A 3.5mm stereo Auxiliary Input socket located on the top left hand corner
of your radio is provided for connecting the audio signal from an external
audio source such as an iPod, MP3 or CD player.
1. Connect a stereo lead from the headphone output of your MP3 or
CD player to the Aux In socket located at the top left hand corner of
the radio. Typically this lead will have a 3.5mm stereo plug at both
ends.
2. Switch on your radio.
3. Press the Mode button until AUX in mode is shown on the display.
4. Press the 'Play' on the connected audio device. If you are using its
headphone output for the connection, set its volume control to a level
of somewhere between two-thirds and maximum (the objective is to get
a strong audio signal but without distortion). Then adjust the volume
on the radio as required.
Note, if using an iPod as the sound source, you may need to set its
output to maximum to get an adequate audio signal level.
5. After use, we recommend that you disconnect your player in order to
listen to your radio conventionally.
1
4
3