Roberts Radio iStream - Manual (Page 67)

If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri)
FM Radio
Operating your radio in FM mode
1. Carefully extend the telescopic aerial and press and hold the On/Off
control to switch on your radio.
2. Press the Mode button as needed to select FM radio mode.
3. Rotate the Tuning/Select control in a clockwise direction. The displayed
frequency will increase. Press the Tuning/Select control to carry out
an auto-tune. Your radio will scan up the FM band from the currently
displayed frequency and will stop scanning when it finds a station of
sufficient strength.
4. The display will show the frequency of the signal which has been
found. If RDS information is available, after a few seconds the display
will show the radio station name.
If you only hear hiss or interference, simply press the Tuning/Select
control to scan further. Your radio may have found a spurious interference
signal.
5. To find more FM stations press the Tuning/Select control to repeat the
scan operation. To scan down in frequency, rotate the Tuning/Select
control in a anti-clockwise direction first and then press the control.
Your radio will scan down the FM band from the currently displayed
frequency and will stop scanning when it finds a signal of sufficient
strength.
6. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
7. Use the Volume control to adjust the sound level as needed.
66
FM Radio .
2
3-5
1,7