Roberts Radio iStream - Manual (Page 84)

83
Brightness control
The brightness of the display can be adjusted for when the radio is in
Stand-by and for when it is in use. If you use the unit in the bedroom, you
may prefer a lower stand-by brightness level than the standard setting.
There are three brightness levels and an almost off 'night-time' setting.
1. Press and hold the On/Off button to switch on your radio. Access the
menu for the current mode by pressing the Menu button.
2. Rotate the Tuning/Select control until 'System settings' is highlighted
on the display. Press the control to enter the system settings menu.
Rotate the Tuning/Select control until 'Brightness' is highlighted on
the display. Press the control.
3. To adjust the display brightness when the radio is switched on rotate the
Tuning/Select control until 'Normal' is highlighted on the display.
To adjust the display brightness when the radio is in stand-by rotate
the Tuning/Select control until 'Standby' is highlighted.
Press the control to enter the selected brightness adjustment mode.
4. To adjust the brightness level rotate the Tuning/Select control clockwise
to increase the brightness level and anti-clockwise to decrease it.
The backlight level will change as the control is rotated so that you
can see the effect of each setting. Note that the backlight is almost
completely off at the zero setting. Press the control to set the level.
Press the Menu button to exit.
When the radio is in Stand-by mode, pressing a button or turning one of the
rotary controls will cause the radio to switch to the Normal brightness level
for a few seconds. This is so that even if the Stand-by brightness level is
set to zero, it is still possible to see the time by quickly pressing a button.
1,4
2-4