Mounting well into system return loop, Pipe - front-mounted loop – Raypak RAYTHERM P-926 User Manual
Page 13
13
2. Lace metal strapping or clamps, (NOT PROVID-
ED) through the ¾” slots on the cover and fasten
securely to pipe as shown in Fig. 15 & 16. Do not
over-tighten clamps.
Fig. 13: Poolstat Control
Fig. 14: Control Cover
Fig. 15: Hose Clamp Slots
Fig. 16: Insert Clamps
3. Remove either the left or right “knock-out” for
wiring on the poolstat control as shown in Fig. 17.
4. Attach appropriate conduit and connectors to the
poolstat control.
5. Attach wires to the poolstat wire terminals. See
Fig. 18.
6. Install poolstat control to the cover and fasten
cover screws.
7. Poolstat should be mounted level as shown in Fig.
19.
Fig. 17: Remove Knockout
Fig. 18: Attach Wires
Fig. 19: Mount Level
This manual is related to the following products: