beautypg.com

Installation, Louver installation, Flueing introduction – Regency FIREGENIE FG39-NG User Manual

Page 7: Installation precautions, Safety precautions for the installer

background image

Regency FG39 FireGenie Freestanding Gas Stove

7

LOUVER

INSTALLATION

1) Attach the top & bottom louvres to the

side stove panel using 2 screws per

side.

INSTALLATION

FLUEING

INTRODUCTION

The DV Stove Horizontal Flue Kit and the Simp-

son Dura-Flue Room Sealed System Model DV-

GS fluing systems, in combination with the

Regency Room Sealed Freestanding Gas Stove,

FG39-NG, and FG39-LPG, have been tested

and listed as direct flue heater systems by

AGA.

These units use the "balanced flue" technology

Co-Axial system. The inner liner flues products

of combustion to the outside while the outer

pipe draws outside combustion air into the

combustion chamber thereby eliminating the

need to use heated room air for combustion and

losing warm room air up the chimney.

Note: These flue pipes must not be con-

nected to any other appliance.

The gas appliance and flue system must be

flueed directly to the outside of the building, and

never be attached to a chimney serving a

separate solid fuel or gas burning appliance.

Each direct flue gas appliance must use it's own

separate flue system. Common flue systems

are prohibited.

IMPORTANT

Read all instructions carefully before starting

the installation. Failure to follow these instruc-

tions may create a fire or other safety hazard,

and will void the warranty. Be sure to check the

fluing and clearance to combustible require-

ments. Consult your local building codes before

beginning installation.

The location of the termination cap must con-

form to the requirements in the Exterior Flue

Termination Locations diagram on page 8.

INSTALLATION

PRECAUTIONS

These fluing systems are engineered products

that have been designed and tested for use

with the FG39-NG, and FG39-LPG. The war-

ranty will be voided and serious fire, health or

other safety hazards may result from any of

the following actions:

1) Installation of any damaged Room Sealed

component

2) Unauthorized modification of the Room

Sealed System

3) Installation of any component part not man-

ufactured or approved by Simpson Dura-

Flue or FPI Fireplace Products International

Ltd.

4) Installation other than as instructed by

Simpson Dura-Flue and FPI Fireplace Prod-

ucts International Ltd.

Warning: Always maintain required

clearances (air spaces) to nearby

combustibles to prevent a fire haz-

ard. Do not fill air spaces with insu-

lation.

Be sure to check the flue termination clearance

requirements from decks, windows, soffits,

gas regulators, air supply inlets and public

walkways as specified in the Exterior Flue

Terminal Locations on page 8 and in your local

building codes.

The gas appliance and flue system must

be flueed directly to the outside of the

building, and never be attached to a chim-

ney serving a separate solid fuel or gas-

burning appliance. Each direct flue gas ap-

pliance must use it's own separate flue sys-

tem. Common flue systems are prohibited.

SAFETY

PRECAUTIONS FOR

THE INSTALLER

1) Wear gloves and safety glasses for

protection.

2) Exercise extreme caution when us-

ing ladders or on roof tops.

3) Be aware of electrical wiring loca-

tions in walls and ceilings.

This manual is related to the following products: