Roland FR-7/FR-5 - Manual (Page 18)

Setting up | First steps
18
r
FR-7/FR-5 V-Accordion
Selecting Easy or Full mode
At first, the FR-7/FR-5 is configured to start up in
“Easy” mode. In that mode, only the main parameters
can be selected. It has the advantage that you do not
feel overwhelmed by the FR-7/FR-5’s possibilities. The
downside, however, is that there are certain (albeit
rather specialized) parameters you cannot even select.
To use the full potential of your FR-7/FR-5, you need to
select “Full” mode:
(1) Switch on the FR-7/FR-5.
See “Switching the power on and off” on p. 15. The
display now looks more or less as follows:
Let us agree to call this page the “Main page”.
(2) Press and hold the [EXIT÷JUMP] button until the
display looks as follows:
(3) Press registers [8] and [2] to jump to the following
page:
(4) Press the [DATA÷ENTER] knob.
(5) Rotate the [DATA÷ENTER] knob or press the [UP]/
[DOWN] buttons to select either “Full” (show all
parameters) or “Easy” (show only the main param-
eters).
(6) Press [EXIT÷JUMP] to return to the main page.
The FR-7/FR-5 asks you whether you want to save your
changes:
“YES” is selected by default. To save your changes, pro-
ceed as described below. (If you don’t want to save
them, turn the [DATA÷ENTER] knob to select “NO”, then
press the [DATA÷ENTER] knob.)
To save your changes:
(7) Press the [DATA÷ENTER] knob. The display now
responds with:
Note: The GLOBAL page shows all parameters that are saved
to the Global memory (there is only one such memory).
(8) Press the [MENU÷WRITE] button to save your
changes. The display briefly shows a confirmation:
Note: If you selected “NO”, the edited Global settings will be
used until you switch off the FR-7/FR-5 (or change them
again).