Roland MC-09 - Manual (Page 22)

22
Using the MC-09 as a synthesizer
Adjusting the pan
Here’s how to adjust the pan (stereo position) of a pattern.
1
Select a pattern.
2
Press the button of the selected group ([LEAD], [BASS],
[RHYTHM]) once again.
The display will show “Pan” for a moment, then the pan setting.
3
Use the [INC] and [DEC] buttons to adjust the pan setting.
This can be adjusted in a range of L64 (left)–cnt (center)–R63 (right).
4
When you are finished adjusting the setting, press the [EXIT]
button.
The display will return to the state in which it was before you began
adjusting the pan.
* If you select a different pattern or turn off the power, the pattern will revert to its
original pan setting. If you want to keep your new setting, you must carry out the
Save procedure (p. 30).
Adjusting the pitch
Here’s how to adjust the pitch of a pattern. This is useful when you want to
play back the pattern in a different key, or when you are playing together
with a transposed instrument.
1
Press the [SETUP] button.
2
Press the [INC] or [DEC] button until the display indicates
“
” (Transpose).
3
Press the [ENTER] button.
The display will show the transpose setting.
4
Use the [INC] and [DEC] buttons to adjust the transpose setting.
You can transpose the pitch in semitone steps over a range of one octave
upward or downward. To raise the pitch one semitone, specify “1.” To
lower the pitch one semitone, specify “-1.”
5
Press the [SETUP] button to complete the setting.