ResMed C16389 - Manual (Page 37)

32
There is excessive leak. Adjust position of mask and
headgear.
Plugs may be missing from
ports on mask. Replace
them.
Air tubing not connected
properly. Connect firmly at
both ends.
Air tubing kinked or
punctured. Straighten or
replace.
VPAP Malibu unit does
not stop when you
remove your mask. Mask Alarm has been
enabled; SmartStop has
automatically been
disabled. Disable Mask Alarm to
enable SmartStop.
Use of a full face mask. SmartStop does not work
with a full face mask.
SmartStop is enabled
but the flow generator
does not stop
automatically when
you remove your mask. Incompatible humidifier or
mask system being used. Use only equipment as
recommended and supplied
by ResMed.
Display error message:
Check tube!!
Key if done
The air tubing is loose.
Air tubing is blocked.
The device motor may not
be running at the correct
speed..
Check that the air tubing is
connected securely to your
mask and the air outlet on
the front of the
VPAP Malibu.
Check air tubing for
blockage.
Return your unit for
servicing.
To clear the error message,
press any key on the
VPAP Malibu keypad.
Problem Possible Cause Solution
268106r1.book Page 32 Thursday, November 30, 2006 2:35 PM