ResMed C16389 - Manual (Page 32)

27 Cleaning and Maintenance
En
glish
Cleaning and Maintenance
You should regularly carry out the cleaning and maintenance described here.
Daily
1. Disconnect the air tubing and hang it in a clean, dry place until next use. Do
not hang the air tubing in direct sunlight as it may harden and crack over time.
2. Clean the mask according to the mask user instructions.
3. If you are using a humidifier, clean it according to the instructions in the
manual.
Weekly
1. Remove the air tubing from the
VPAP Malibu unit and the mask.
2. Wash the mask system according to the instructions supplied with it.
3. Wash the air tubing in warm water using mild detergent. Rinse thoroughly,
hang and allow to dry.
4. Before next use, assemble the mask and headgear according to the mask
user instructions.
5. Reconnect the air tubing to the air outlet and mask.
!
CAUTION
• Do not use bleach, chlorine-, alcohol- or aromatic-based solutions
(including all scented oils), moisturizing, or antibacterial soaps to clean
the cushion, mask, air tubing, or the VPAP Malibu. These solutions may
cause hardening and reduce the life of the product.
• Do not wash or dry the mask frame at a temperature above 176 o F (80 o C).
Exposure to higher temperatures may reduce the life of the product.
• Do not hang the air tubing in direct sunlight as the tubing may harden
over time and eventually crack.
Periodically
1. The mask and air tubing are subject to normal wear and tear. Inspect them
regularly for damage.
2. Clean the exterior of the flow generator with a damp cloth and mild
detergent.
3. Inspect the air filter to check if it is blocked by dirt or contains holes. See
“Replacing the Air Filter” on page 28.
!
WARNING
Beware of electric shock. Do not immerse the flow generator or power cord
in water. Always unplug the flow generator before cleaning and be sure that
it is dry before reconnecting.
268106r1.book Page 27 Thursday, November 30, 2006 2:35 PM