Roberts Radio WiFi Internet Radio WM-202 User Manual

Page 44

Finding new stations - DAB

Should you wish to use your radio for DAB reception in a new location,

or if no stations were detected during the initial scan, you can follow this

procedure to allow your radio to ﬁnd out which DAB radio stations are

available.

1. Ensure that the telescopic antenna is extended, and then repeatedly

press the Mode button until the radio is in DAB mode.

2. Once in DAB mode press and release the Menu button.

3. Rotate the Tuning/Select control until "Local scan" is highlighted on

the display.

4. Press and release the Tuning/Select control and the display will show

"Scanning". Your radio will perform a scan of the UK DAB frequencies.

As new stations are found the station counter on the right hand side

of the display will increase and stations will be added to the list.

5. To carry out a full scan of the entire DAB band III frequencies rotate the

Tuning/Select control until "Full scan" is highlighted on the display.

6. Press and release the Tuning/Select control and the display will show

"scanning". As new stations are found the station counter on the right

hand side of the display will increase and stations will be added to the

list.

3,4

WM-202 iss 1.indd 44

20/02/2008 13:03:58