Conﬁguration – Roberts Radio WiFi Internet Radio WM-202 User Manual

Page 15

Entering the WiFi network name manually

If your network is conﬁgured with a hidden ESSID, then you will need to enter the network name manually.

This is part of the manual conﬁguration options for your radio. As such you will also be required to set up

some other network details manually. Unless you are familiar with networking and related terminology, we

recommend that you set your router to allow your ESSID to be broadcast. (While a hidden ESSID may

prevent casual observers from detecting your network, it is not recommended as a means of network

security.)

1. From the radio’s Internet setup menu, select 'Manual settings'. You then have a choice of 'Wired' or

'Wireless' networks. Choose 'Wireless'. The next menu asks whether you wish to use DHCP to conﬁgure

your network. Choose 'DHCP enable' unless you need to specify all network details manually.

2. The next screen allows you to manually set up the ESSID. Characters are selected and entered using

the Tuning/Select control. As you rotate the control, the radio shows different sets of characters. The

character currently ﬂashing will be selected when you press the Tuning/Select control. Do this as

needed until the complete key has been entered. The three characters at the right-hand end of the

list have special functions.

select '

<' to erase a character or key previously entered

select ' ' when the ESSID is complete

select '

C' to go back to the previous menu

3. You will then be asked for details of the encryption key for your network. You must choose the type of

encryption and then enter the key using the same method as used for the ESSID. This is described

in more detail on pages 11 and 12.

4. If you selected 'DHCP enable' in step 1, the radio will then try to connect to the named network.

5. If you selected 'DHCP disable' in step 1, you will then need to enter the remaining network details,

including IP address, subnet mask, gateway and DNS details. This is covered in more detail on

page 66.

Conﬁguration .

Wizard

PC settings

View settings

>Manual settings

Wired

>Wireless

>DHCP enable

DHCP disable

WM-202 iss 1.indd 15

20/02/2008 13:03:35