Roberts Radio WiFi Internet Radio WM-202 - Manual (Page 11)

10
If your network allows automatic configuration the radio will acquire
a network address, and will then enter the main Internet Radio menu
(paragraph 14 overleaf).
There are two indicator lights incorporated into the RJ-45 connector.
If you have problems with your wired connection, they may help you
to identify the possible cause of the problem.
Green ON = Link established; OFF = no connection
Yellow Flashing = Data transfer
If you need to specify the network settings (if your network does not
support automatic configuration or if you do not want to use it) then
you should select [Manual Config] instead of selecting "[Wired]" in the
Network Wizard.
6. If you wish to use a WiFi connection, you will first need to identify
your network in the list of network names presented by the Network
Wizard. If the radio cannot find any networks then you will have to
get your wireless access point working - please see the instructions
supplied with it.
When the radio finds your wireless network, it displays the Network
Name (ESSID) for the access point on the screen. This is a name that
is allocated to the access point by the person who set up the network
- for example: 'Jones family' or 'Paul's network'.
It is possible, and in some locations highly likely, that your radio will
find more than one wireless access point, in which case you should
choose which one you need to connect to.
7. Rotate the Select control to see the ESSID for each access point that
the radio has found. If your network is shown proceed to step 9 on the
next page.
Configuration .
Network wizard
Scanning...
>Jones family
Paul’s network
Smith
[Rescan]
5
5
WM-202 iss 1.indd 11 20/02/2008 13:03:31