Roberts Radio WiFi Internet Radio WM-202 User Manual

Page 34

Connecting the radio using UPnP

1. Press the On/Off button to switch the radio on. Then press the Mode

button to select Music Player mode.

2. Press the Menu button to enter the main Music Player menu. Rotate

the Tuning/Select control until "Browse" is selected on the display.

Press the Tuning/Select control to select.

3. Rotate the Tuning/Select control until 'Shared media' is selected on

the display. Press the Tuning/Select control to select. The radio will

scan for all available UPnP servers. Note, this may take a few seconds

for the radio to complete its scan. The radio will display '' if

no UPnP servers are found.

3. After scanning, select your UPnP server using the Tuning/Select

control. If you are using WMP 11 as the server, your radio will then

normally display 'Unauthorised - Select to retry' at this stage.

4. Your PC may prompt you that there has been a connection to your

UPnP server. Whether prompted or not, to allow the radio to access

the media ﬁles, you will need to click the 'Library' tab in WMP 11 and

select the 'Media Sharing…' item to open the 'Media Sharing' window.

Make sure the box 'Share my media to:' is ticked.

5. In the 'Media Sharing' window, the radio will be listed as an unknown

device. Click on the unknown device shown to select it, then click the

'Allow' button and then click 'OK'.

Note: If you are using Microsoft Windows' ﬁrewall software, this should

be correctly conﬁgured by WMP 11. If you are using third party ﬁrewall

software you may need to manually conﬁgure it to allow your radio

and WMP 11 to communicate (see 'Troubleshooting' on page 65).

6. Select the named server again using the Tuning/Select control.

If WMP 11 is now able to communicate with your radio you will be

presented with some media selection options on the radio display.

Allowing a device to connect to Windows Media Player 11

2-6

Unauthorised

Select to retry

WM-202 iss 1.indd 34

20/02/2008 13:03:53