Roberts Radio WiFi Internet Radio WM-202 - Manual (Page 12)

Connecting to your computer network - contd.
8. If your network is not found, it is possible that it is configured such that
the ESSID is not broadcast (sometimes referred to as hidden). If this
is the case then the name will not be visible in the list (there may be
a blank entry). You will then need to use the Tuning/Select control to
point to the '[Manual Config]' option, and then you should press the
control to enter manual configuration. This procedure is described in
the 'Network Configuration Menu', see page 14, 'Entering the network
name manually'.
If you know that your network name is not hidden, and it was not found,
then either try re-scanning, or refer to 'Entering the WiFi network name
manually' on page 14.
If you make a mistake at any point, use the Back option to go back to
the previous screen.)
9. When the ESSID for the access point you want to connect to is
highlighted on the screen, press the Select control.
10. If your network is configured without an encryption code, the screen
should say 'Connecting...', and then show the main Internet Radio
menu.
If this is the case then you have successfully connected your radio to
your network, so please proceed to paragraph 14 on the next page.
11. If the screen displays 'Key:' , it is because the network is using one
of the encryption systems: Wired Equivalent Privacy (WEP) or WiFi
Protected Access (WPA). You therefore need to enter the correct
WEP or WPA key into the radio to allow it to communicate with your
network.
If you do not have the WEP or WPA key, then you should obtain it from
the person who set up your network. Some WiFi routers may come
with a key already set up by the supplier, in which case you should
refer to the user documentation provided with it.
11
Key:
0123456789< C
�
>Jones family
Paul’s network
Smith
[Rescan]
8-9
Smith
[Rescan]
[Wired]
>[Manual config]
WM-202 iss 1.indd 12 20/02/2008 13:03:32