Figure 3-12 . connecting 12-volt trigger outputs, Connecting to ac power, 12. connecting 12-volt trigger outputs – Runco CL-810 CL-810 Ultra Cl-810 CineWide CL-810 / SDC-1 User Manual
Page 40: Pre l iminar y
28
Runco CL-810 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Connecting 12-Volt
Trigger Output to External
Theater Components
If your CL-810 is equipped with a CineWide with AutoScope system, or if your home
theater contains other devices that respond to 12-volt triggers (such as a retractable
screen or screen mask), connect it to the 12-volt trigger output as shown in Figure 3-12.
Figure 3-12. Connecting 12-Volt Trigger Outputs
Connecting to AC Power
The CL-810 ships with various types of AC power cords. Choose the one that is
appropriate to your locale.
Plug the female end of the power cord into the AC receptacle on the rear of the projector
(AC 100V ~ 240V). Then, connect the other end to your AC power source.
➤
S-VID /
S-VID
to CineWide with AutoScope
system or other home
theater components
(screen, screen mask etc.)
3.5-mm
mini plug
➤
Power
switch