Radio Shack 43-3701 - Manual (Page 7)

Installation
7
Connecting to the Phone Lines
To take full advantage of the phone’s
capabilities, you must have two phone lines
with separate phone numbers. If you have
only one line, you can order a second from
your phone company.
"
You can connect the phone to the lines in
one of three ways:
• connect two lines through a two-line
modular phone jack
• connect two lines through two one-line
modular phone jack
• connect one line through a one-line
modular phone jack.
• If you connect the phone to a two-line
phone jack with a two-line cord, do not
connect a third line to the
TEL LINE 2
jack or the phone will not operate
properly. Instead, you can connect
another phone device, such as a fax
machine or modem.
• To connect the phone to two one-line
phone jacks, plug one end of the
supplied long two-line modular cord
into
TEL LINE 1/2 and plug another cord
(not supplied) into the TEL LINE 2 jack.
Route both cords through the strain-
relief slot on the base.
On a Desk Top
1. To connect the
phone to a two-
line phone jack,
plug one end of
the supplied long
two-line modular
cord into the
TEL
LINE 1/2 jack on
"
CAUTION
"
•You must use a
Class 2 power
source that
supplies 9V DC
and delivers at least 350 mA.
Its center tip must be set to
positive and its plug must fit
the phone's
DC IN 9V jack.
The supplied adapter meets
these specifications. Using an
adapter that does not meet
these specifications could
damage the phone or the
adapter.
• Always connect the AC
adapter to the phone before
you connect it to AC power.
When you finish, disconnect
the adapter from AC power
before you disconnect it from
the phone.
!
DC IN 9V TEL LINE
43-3701.fm Page 7 Thursday, April 24, 2003 11:56 AM