Radio Shack 43-3701 User Manual
Page 23
Setting Menu Options
23
2. Press the
/INTCM
key or the
/CONF
key to select “
L
L
L
Li
i
i
in
n
n
ne
e
e
e
1
1
1
1
” or “
L
L
L
Li
i
i
in
n
n
ne
e
e
e
2
2
2
2
”.
3. Press
#/>
.
4. Press the
/INTCM
key or the
/CONF
key to move the cursor to the selection
that you would like to change. Press the
SELECT/VOL/RING
key to toggle
between “
O
O
O
On
n
n
n
” and “
O
O
O
Of
f
f
ff
f
f
f
”.
5. After you have made your selections,
press the
CID/MENU/HOLD
key or return
the handset to the base. Ô
Choosing the Dialing Mode
Most phone systems use tone dialing which
sends DTMF tones through the phone lines.
However some phone systems still use pulse
dialing such as in rural areas. The default
setting is tone dialing. Depending on your
dialing system, set the mode as follows: Ô
1. Press and hold the
FLASH
key on the
base until you hear a confirmation tone.
2. To set the dial mode for pulse dialing,
press
#
on the base. Or to set the dial
mode for tone dialing, press
/tone
on
the base. A confirmation tone sounds
to indicate the setting is complete.
• If you are not sure of your dialing
system, set for tone dialing. Make a trial
call. If the call connects, leave the
setting as is, otherwise set for pulse
dialing.
• If your phone dialing system requires
pulse dialing and you need to send
DTMF tones for certain situations
during a call, you may "switch-over" to
tone dialing. (See “Tone Dialing Switch-
over” on page 14.)
Ô
NOTES
Ô
To Change Your Auto
Talk and CIDCW:
Please return the handset
to the base after you set
CIDCW.
Choosing the Dialing
Mode
Make sure your battery
pack is fully charged before
setting Caller ID options.
43-3701.fm Page 23 Thursday, April 24, 2003 11:56 AM