Ricoh Caplio RX - Manual (Page 107)

107
7
Changing the Operation
Sound Setting (BEEP
SOUND)
During operations, the camera makes three
types of sounds - start sound, shutter release
sound, and beep sound.
You can change the setting to mute these
operation sounds.
To change the setting of operation sound, fol-
low the steps below.
1.
Turn the Mode Dial to 1 1 1 1
(Setup Mode).
The Setup Screen appears.
2.
Press the " " " " button to select
[BEEP SOUND].
3.
Press the #$ #$ #$ #$ buttons to select
the desired setting.
This setting will be used until you change
it.
Changing Image Confir-
mation Time (LCD CON-
FIRM.)
Immediately after pressing the shutter button,
the still image taken is displayed for a
moment so you can check it.
At purchase, Confirmation Time is set to one
second, but this can be changed.
To change Confirmation Time, follow the
steps below.
1.
Turn the Mode Dial to 1 1 1 1
(Setup Mode).
The Setup Screen appears.
2.
Press the " " " " button to select
[LCD CONFIRM.].
3.
Press the #$ #$ #$ #$ buttons to select
the desired setting.
This setting will be used for shooting until
you change it.
Start sound : Sound when the camera power
is turned on.
Shutter release sound : Sound when the shutter release
button is pressed.
Beep sound : Shot images are recorded imme-
diately in the internal memory or
on an SD memory card. At
recording, the camera makes a
short beep.
Possible Settings
SHUTTER
ON (all sounds on) *Initial setting at purchase
OFF (all sounds off)
Possible Settings
OFF (Photo not displayed for confirmation)
1 Minute (Default)
2 Seconds
3 Seconds