Settings required to use scan to folder function, Ethernet – Ricoh LD435c User Manual
Page 33
Network Settings
25
1
Note
❒ For the Effective Protocol setting, check that the protocol you want to use is
set to [Active].
❒ [LAN Type] is displayed when the wireless LAN interface board is installed. If
both ethernet and wireless LAN (IEEE 802.11b) are connected, the selected in-
terface takes precedence.
❒ When POP before SMTP is set to [On], you must also make settings for Recep-
tion Protocol and POP3 / IMAP4 Settings.
❒ When setting POP before SMTP to On, check POP3 port number in E-mail
Communication Port.
Reference
p.59 “Interface Settings”
p.69 “File Transfer”
Settings Required to Use Scan to Folder Function
This section lists the settings required for sending files.
Ethernet
This section lists the settings required for sending files with an Ethernet connection.
For details about how to specify the settings, see "Interface Settings" and "File
Transfer".
Menu
User Tool
Setting Requirements
Interface Settings/Network
Machine IPv4 Address
Necessary
Interface Settings/Network
IPv4 Gateway Address
Necessary
Interface Settings/Network
DNS Configuration
As required
Interface Settings/Network
DDNS Configuration
As required
Interface Settings/Network
Domain Name
As required
Interface Settings/Network
WINS Configuration
As required
Interface Settings/Network
Effective Protocol
Necessary
Interface Settings/Network
Ethernet Speed
As required
Interface Settings/Network
LAN Type
Necessary
Interface Settings/Network
Permit SNMPv3 Communication
As required
Interface Settings/Network
Permit SSL/TLS Communication
As required
Interface Settings/Network
Host Name
As required
File Transfer
Scanner Resend Interval Time
As required
File Transfer
Number of Scanner Resends
As required