beautypg.com

Absolute maximum ratings, Critical design guide and diagram – RoyalTek REB-3000 User Manual

Page 15

background image

RoyalTek RGM-3000/REB-3000
GPS Module Operational Manual)

10

VCC DC Power Input

This is the main power supply for the Engine

board. The power range is from 3.3V±10%,

ripple

200mV. The maximum current of

RGM-3000 is

200mA.

GND

GND provides the ground for the Engine

board. Connect all grounds.

VBAT

This is the battery backup supply that

powers the SRAM and RTC when main

power is removed. The input voltage level is

from 2.1V~3.6V. Max current draw is 10 uA

at 3.3volt. Without an external backup

battery or on board battery, engine board will

execute a cold start after every turn on. To

achieve the faster start-up offered by a hot

or warm start, either a backup battery must

be connected or battery installed on board.

TXA

This is the main transmit channel and is

used to output navigation and measurement

data to user written software. The default

setup is NMEA Output, 4800bps, 8 data bits,

no parity, 1 stop bit. The default sentences

are GPGGA, GPGSA, GPRMC once per

second and GPGSV once per 5 seconds.

Please refer to “software interface” for the

detail protocol.

RXA

This is the main receiving channel and is

used to receive software commands to the

Engine board from user written software.

Please refer to “software interface” for the

detail protocol.

RXB

This is used for DGPS differential input .

BOOTSEL

Pull Bootsel pin high & reset , then it will get

to boot mode.

GPIO

This pin can be programmed to input or

output. For more application, please contact

Royaltek’s sales.

Absolute maximum ratings

Parameter

Symbol

Unit

Min. Value

Max. Value

Supply voltage

VCC

V

2.97

3.63

Output current

mA

200

Critical design guide and diagram

1. It is recommanded to attach GNDu plate (30*30MM) below RGM3000M module or the antenna

module of RGM-3000E to increase the intensity of reception . Please refers to “Design Layout

Diagram “ .

2. During design of integrated layout, please isolate high frequency noise source (power Switch,data

or address signal lines ) from GPS antenna.

3.

Please don’t place metal object above patch antenna.

This manual is related to the following products: