Regency P121 - Manual (Page 25)

Regency ® P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace 25
CONVERSION KIT #731-969 FROM NG TO LP
FOR P121-2/P121LC-2/P121RC-2/P131-2 USING SIT 820 NOVA GAS VALVE
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
INSTALLATION
5) Pull off the pilot
cap to expose
the pilot orifi ce.
6) Unscrew the pilot orifi ce with the allen key
and replace with the LPG pilot orifi ce in
the kit and replace pilot cap.
7) Remove burner orifi ce with a 1/2" wrench
to hold onto the elbow behind the orifi ce
and discard the orifi ce.
Burner Orifi ce
1) Remove the louvers and trim kit. Remove
the front door.
2) Remove the logs, embers.
Each Kit contains one LPG
Conversion Kit and one DC
Sparker Kit.
LPG Conversion Kit Contains:
Qty. Part
# Description
1 904-529 5/32" Allen Key
1 904-641 Burner Orifi ce #50
1 918-590 Decal "Converted to
LPG"
1 908-528 Red "LPG" label
1 910-037 LPG Injector
(Pilot Orifi ce)
1 918-485 Instruction Sheet
DC Sparker Kit Contains:
Qty. Part
# Description
1 820-475 Bracket DC Sparker
1 820-476 Bracket DC Sparker
1 904-153 Washer #8 External Star
1 904-330 Nut 8-32 Hex
2 904-531 Bushing Split Plastic
0.500 in.
1 904-543 Screw 8-32 x 3/4
Pan Head
2 904-553 Screw #8 x 1/2 Type "B",
Black Oxide
1 910-073 Spark Generator
Battery Holder
1 910-074 Spark Generator Switch
C/W Wire
1 910-078 Battery Size AA
Energizer En91
2 910-199 Clip Wire Holder
1 910-903 Wire Fan To Power Cord
Ground 30 in.
904-781 Velcro Hook, Black
904-782 Velcro Hook, Black
Diagram 1 and 2: Remove the left and right
screws and then slide the burner assembly
away from the orifi ce and lift out.
4) Remove the burner assembly by remov-
ing the 4 Phillips head screws and then
slide the burner assembly away from the
orifi ce and lift out.
8) Reinstall new burner orifi ce LPG stamped
#50 and tighten.
9) Turn control knob to the “OFF” position.
10) Remove the black protection cap by hand
from the high-low knob (Fig.1).
Fig. 1
3) Remove the grate by lifting straight up.
Remove the side brick panels (if
installed). The brick panel is very
fragile - handle with care.
Installation of LPG
Conversion Kit:
Diagram 1
Diagram 2