Roberts-Gordon HE15UT - Manual (Page 17)

SECTION 5: G ENERAL S USPENSION D ETAILS
11 of 73
SECTION 5: GENERAL SUSPENSION DETAILS
To ensure your safety, and comply with the terms of the
warranty, all units must be installed in accordance with
these instructions.
The gas or the electrical supply lines must not be used to
support the heater.
Do not locate the gas or electrical supply lines directly
over the path of the flue products from the heater.
The heater must be installed in a location that it is readily
accessible for servicing.
The heaters must be installed with clearances to
combustibles as indicated on the rating plate and in this
manual.
The minimum and maximum gas inlet pressures must be
maintained as indicated on the rating plate. Typical
installation configurations are shown on Page 12, Figure
17.
NOTE: Some models may receive S-hooks (P/N
91907302) or spring hooks (P/N 91903300), rather than
bow shackles.
WARNING
Severe Injury Hazard
Secure burner to burner tube with bolts and
lockwashers.
Hang heater with materials with a minimum
working load of 75 lbs (33 kg).
Failure to follow these instructions can result
in death, injury or property damage.
WARNING
Cut/Pinch Hazard
Wear protective gear during installation,
operation and service.
Edges are sharp.
Failure to follow these instructions can result
in injury.