NEC NX7700i/5040H-32 - Manual (Page 129)

Base Module
855-900547-200 2-93
2.4.6.15. UP (Bring up System)
m b u
X
* This command is valid to inactive partitions (DC Off).
Function:
This command is used to turn the system DC power On, initialize the hardware, and boot up the
BIOS. Whether to subsequently boot the OS depends on the BIOS/EFI settings.
(Screen Example)
Description
No.
iSPyz:---> up
This command will bring up the specified partition.
Enter partition number (0-7/all/CR=exit) : all (a)
Execute OK? (y/[n]) y (b)
UP command was accepted. All partitions will run soon. (c)
mm/dd/yyyy HH:MM:SS 0------- System initialization started. (SPFW:Rxx.xx)
[iSP0m:INFO.2094] partition 0 : turning on POWBAY(s)...
:
mm/dd/yyyy HH:MM:SS 0------- System initialization completed. (SPFW:Rxx.xx)
[iSP0m:INFO.2129] partition 0 : handed off the control to BIOS.
(DIPSW = 00000000)
(d)
(Description)
Description
No.
Description
(a)
Enter partition number.
If “all” is specified, all the existing partitions are the target of this command.
(b)
A confirmation message appears.
If you are sure to continue, enter “y.”
If the first 1 byte of the BIOS virtual DIPSW is not zero, the following confirmation
message will appear:
Partition x BIOS virtual DIPSW is ON.(DIPSW=xxyyyyyy) Continue? ([y]/n)
If you are sure to continue the boot process, enter “y.” If you wish to abort, enter
“n.”
(c)
A “UP command accepted” message appears.
The actual boot is performed in the background.
(d) Shows boot progress in the background.
End of SEC2