NEC HT1100 - Manual (Page 13)

E-13
Making Connections
PC CONTROL
COMPUTER IN
DVI-D IN
SC TRIGGER
VIDEO IN S-VIDEO IN
S-VIDEO S-VIDEO RGB/DVI RGB/DVI VIDEO VIDEO AUDIO IN AUDIO IN COMPONENT
Y Cb/Pb Cr/Pr
VCR, DVD Player or
LaserDisc Player
Macintosh
(Desktop type or notebook type) IBM VGA or Compatibles
(Desktop type or notebook type)
DVD Player
(with component output)
Video Game
To video, S-video,
and audio inputs
on the projector.
Component video cable
(RCA
ן 3)
(Supplied)
RGB Signal cable (supplied)
To mini D-Sub 15-pin connector on
the projector. It is recommended
that you use a commercially avail-
able distribution amplifier if con-
necting a signal cable longer than
the supplied cable.
NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the power to the notebook PC. In most
cases signal cannot be output from RGB output unless the notebook PC is turned on after connecting with the projector.
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power management software.
* If you accidentally hit the POWER button on the remote control, wait 90 seconds and then press the POWER button again to resume.
Wiring Diagram
Set top box